Rear

REMOVAL
1. Remove the trim cover from the rear wiper motor on the inside of the liftglass. (Refer to ELECTRICAL/REAR WIPERS/WASHERS/REAR WIPER MOTOR TRIM COVER - REMOVAL).

Fig. 9 Rear Washer Nozzle Remove/Install:

2. From the inside of the liftglass, disconnect the rear washer supply hose from the barbed nipple on the back of the rear washer nozzle.
3. While holding the hood of the rear washer nozzle securely from the outside of the liftglass, remove the plastic nut that secures the threaded nipple of the rear washer nozzle to the inside of the liftglass.
4. From the inside of the liftglass, push the nipple of the rear washer nozzle out through the mounting hole in the liftglass.
5. Remove the rear washer nozzle and rubber gasket from the outside of the liftglass.

INSTALLATION
1. Position the rear washer nozzle and rubber gasket to the outside of the liftglass with the orifice of the nozzle aimed at the nozzle alignment arrowhead visible on the outside of the glass.
2. From the inside of the liftglass, install and tighten the plastic nut that secures the threaded nipple on the back of the rear washer nozzle to the inside of the liftglass. Tighten the nut to 1 N.m (8 in. lbs.).
3. Reconnect the rear washer supply hose to the barbed nipple of the rear washer nozzle.
4. Reinstall the trim cover onto the rear wiper motor on the inside of the liftglass. (Refer to ELECTRICAL/REAR WIPERS/WASHERS/REAR WIPER MOTOR TRIM COVER - INSTALLATION).