Horn: Service and Repair

REMOVAL
1. Disconnect and isolate the battery negative cable.
2. Raise and support the vehicle.
3. Remove the lower front half of the inner liner from the right front fender wheel house.

Fig.1 Horns Remove/Install:

4. Reach through the front of the right front fender wheel house opening to access and disconnect the two right headlamp and dash wire harness connectors from the horn connector receptacles. Be certain to disengage the connector lock tabs before disconnecting them from the horn connector receptacles.
5. Remove the screw that secures the horn mounting bracket to the right extension of the radiator closure assembly.
6. Remove both horns and the mounting bracket from the right extension of the radiator closure assembly as a unit.

INSTALLATION
1. Position both horns and the mounting bracket onto the right extension of the radiator closure assembly as a unit.
2. Install and tighten the screw that secures the horn mounting bracket to the right extension of the radiator closure assembly. Tighten the screw to 11.3 Nm (100 in. lbs.).
3. Reconnect the two right headlamp and dash wire harness connectors to the horn connector receptacles. Be certain to engage the connector lock tabs after reconnecting them to the horn connector receptacles.
4. Install the lower front half of the inner liner to the right front fender wheel house.
5. Lower the vehicle.
6. Reconnect the battery negative cable.