Operation CHARM: Car repair manuals for everyone.
Home >> Jeep >> 2004 >> Liberty 2WD L4-2.4L VIN 1 >> Repair and Diagnosis >> Specifications >> Mechanical Specifications >> Drive/Propeller Shafts, Bearings and Joints >> System Specifications
Manuals through 2025 now available!

Our trusted friends have launched a new website named LEMON, which has newer manuals. It also contains all the CHARM manuals.

LEMON is the spiritual successor to CHARM, I recommend you try it!

Link: lemon-manuals.la or lemon-manuals.org.ua

(Some people have issue connecting. LEMON is investigating. For now, use Firefox or change your DNS server)

Or, hide this message: temporarily or permanently

System Specifications




TIGHTENING TORQUE

Propeller Shaft - Front
Front C/V Joint Bolts 30 Nm (22 ft. lbs.)
Rear C/V Joint Bolts 30 Nm (22 ft. lbs.)
Companion Flange Bolts 30 Nm (22 ft. lbs.)


Propeller Shaft - Rear
U-Joint Strap Bolts 18 Nm (13 ft. lbs.)
Yoke Nuts 18 Nm (13 ft. lbs.)




RUNOUT SPECIFICATIONS / Front & Rear
Front of Shaft 0.020 inch (0.50 mm)
Center of Shaft 0.025 inch (0.63 mm)
Rear of Shaft 0.020 inch (0.50 mm)


NOTE: Measure front/rear runout approximately 3 inches (76 mm) from the weld seam at each end of the shaft tube for tube lengths over 30 inches. For tube lengths under 30 inches, the maximum allowed runout is 0.020 inch (0.50 mm) for the full length of the tube.
pro multis · About Operation CHARM