Hydraulic System Junction Block: Service and Repair

BRAKE JUNCTION BLOCK

REMOVAL
1. Install prop rod on the brake pedal to keep pressure on the brake system.
2. Remove the brake lines from the junction block (2).





3. Remove mounting nuts (3) and remove the junction block (3) (Fig. 38).

INSTALLATION
1. Install the junction block (2) on the mounting studs.
2. Install mounting nuts (3). Tighten to 14 Nm (125 inch lbs.).





3. Install brake lines to the junction block (2) and tighten to 20 Nm (180 inch lbs.) (Fig. 39).
4. Bleed the brake system.