Compass: Service and Repair

MODULE-REMOTE COMPASS

REMOVAL




1. Disconnect and isolate the battery negative cable.
2. Partially remove the headliner (1) to gain access to the Remote Compass Module (RCM) (2).
3. Disconnect the RCM electrical connector (3).
4. Remove the RCM retaining screws (4).
5. Remove the RCM (2) from the vehicle.

INSTALLATION




1. Position the Remote Compass Module (RCM) (2) into the bracket on the upper side of the headliner (1).
2. Install the RCM retaining screws (4).
3. Connect the electrical connector (3).
4. Install the headliner assembly.
5. Connect the battery negative cable.
6. Perform the Compass Variation Adjustment. Adjustments
7. Perform the Compass Calibration. Manual Compass Calibration
8. Verify proper compass operation.