Second Row
READING LAMPBULB - SECOND ROW
REMOVAL
NOTE: The second row reading lamps are integral to the grab handle in the headliner on the inner roof side rail over each outboard second row seating position.
1. Disconnect and isolate the battery negative cable.
2. Using a small thin-bladed screwdriver, gently pry the upper corner at the forward end (2) of the reading lamp lens (1) away from the grab handle far enough to unsnap it from the lamp housing.
3. Pull the front end of the lens outward far enough to disengage the large tab at the rear of the lens from the lamp housing.
4. Pull the base of the bulb (1) straight out of the bulb holder within the lamp housing.
INSTALLATION
CAUTION: Always use the correct bulb size and type for replacement. An incorrect bulb size or type may overheat and cause damage to the lamp, the socket and/or the lamp wiring.
NOTE: The second row reading lamps are integral to the grab handle in the headliner on the inner roof side rail over each outboard second row seating position.
1. Align the base of the bulb (1) with the bulb holder within the reading lamp housing.
2. Push the bulb into the holder until the base is fully seated.
3. Insert the large tab on the rear end of the lamp lens (1) into the rear of the lamp housing.
4. Using hand pressure, push the small tab at the upper front corner of the lens (2) rearward and inward towards the lamp housing until it snaps into place.
5. Reconnect the battery negative cable.