Operation CHARM: Car repair manuals for everyone.
Home >> Jeep >> 2006 >> Commander 2WD V8-5.7L VIN 2 >> Repair and Diagnosis >> Lighting and Horns >> Center Mounted Brake Lamp >> Service and Repair
Manuals through 2025 now available!

Our trusted friends have launched a new website named LEMON, which has newer manuals. It also contains all the CHARM manuals.

LEMON is the spiritual successor to CHARM, I recommend you try it!

Link: lemon-manuals.la or lemon-manuals.org.ua

(Some people have issue connecting. LEMON is investigating. For now, use Firefox or change your DNS server)

Or, hide this message: temporarily or permanently

Center Mounted Brake Lamp: Service and Repair

CENTER HIGH MOUNTED STOP LAMP

REMOVAL




1. Disconnect and isolate the battery negative cable.
2. Remove the two screws (6) that secure the Center High Mounted Stop Lamp (CHMSL) (8) to the liftgate header panel (1).




3. Pull the CHMSL (1) away from the liftgate far enough to access and disconnect the wire harness connector (2) and the rear washer supply hose (3) from the lamp.
4. Remove the CHMSL from the liftgate.

INSTALLATION




1. Check to be certain that the two plastic nuts (4) are properly installed and in good condition in the liftgate header panel (1).
2. Position the Center High Mounted Stop Lamp (CHMSL) (8) near the opening in the liftgate header panel.
3. Reconnect the wire harness connector (2) to the connector receptacle (7) and the rear washer supply hose (3) to the nipple (5) on the back of the lamp.
4. Position the CHMSL into the liftgate header opening.
5. Install and tighten the two screws (6) that secure the CHMSL to the liftgate header panel. Tighten the screws to 3 N.m (27 in. lbs.).
6. Reconnect the battery negative cable.
pro multis · About Operation CHARM