Without APPS (Accelerator Pedal Position Sensor)

REMOVAL




The following procedure applies only to vehicles without the Adjustable Pedal Package (code XAP). It also applies to vehicles not equipped with an accelerator pedal position sensor.

The accelerator pedal is serviced as a complete assembly including the bracket.
1. From inside the vehicle, hold up accelerator pedal. Remove plastic cable retainer (clip) (2) and throttle cable core wire from upper end of accelerator pedal arm. Plastic cable retainer (clip) (2) snaps into top of pedal arm.




2. Remove two accelerator pedal mounting bracket nuts (3). Remove accelerator pedal assembly (2).

INSTALLATION




The following procedure applies only to vehicles without the Adjustable Pedal Package (code XAP). It also applies to vehicles not equipped with an accelerator pedal position sensor.

The accelerator pedal is serviced as a complete assembly including the bracket.
1. Place accelerator pedal assembly (2) over two mounting studs (1).
2. Install and tighten two mounting nuts (3). Refer to Torque Specifications.
3. Slide throttle cable into opening slot in top of pedal arm.




4. Push plastic cable retainer (clip) (2) into accelerator pedal arm opening until it snaps into place.
5. Before starting engine, operate accelerator pedal to check for any binding.