Ignition Coil: Service and Repair

COIL-IGNITION

REMOVAL




1. Disconnect the electrical connector (1) from coil (3).
2. Clean area at base of coil with compressed air before removal.
3. Remove two mounting bolts (2) (note that mounting bolts are retained to coil).




4. Carefully pull up coil (1) from valve cover.
5. Remove coil (1) from vehicle.

INSTALLATION




1. Using compressed air, blow out any dirt or contaminants from around top of spark plug.

NOTE: Use dielectric grease on each of the spark plug boots before installing the coil.

2. Position ignition coil (1) into valve cover and push onto spark plugs.




3. Install 2 coil mounting bolts (2). Tighten to 7 N.m (62 in.lbs.).
4. Connect electrical connector (1) to coil by snapping into position.