PDC B+ Terminal Module

REMOVAL




1. Remove the PDC housing lower cover.
2. From the top of the PDC housing, use a small screwdriver or a terminal pick tool (Special Tool Kit 6680) to release the two latches that secure the B(+) terminal module in the PDC.
3. Gently and evenly press the two B(+) terminal studs down through the bus bar in the PDC.
4. From the bottom of the PDC housing, remove the B(+) terminal module from the PDC.

INSTALLATION




1. From the bottom of the PDC housing (1) , align and insert the B(+) terminal module (3) into the PDC.
2. From the bottom of the PDC housing (1) , align and insert the two studs of the PDC B(+) terminal module (3) through the bus bar (4) in the PDC.
3. From the bottom of the PDC housing (1) , press the B(+) terminal module (3) gently and evenly into the PDC until both of the latches (2) are fully engaged.
4. Install the PDC housing lower cover.