Removal

REMOVAL




1. Remove the watershield from the inside of the rear door. Refer to Rear Door Panel.




2. Separate and remove the inner belt molding.

3. Temporarily install the window switch and raise the glass into the full up position.

4. Remove the bolts and remove the glass run channel.

5. Loosen the bolt in each of the window regulator glass clamps just far enough to release the door glass from the clamps. Do not completely remove.

6. Disengage the door glass from the window regulator glass clamps.

7. Lower the regulator down as required for access to remove the door glass.

8. Carefully rotate the door glass within the window opening and remove the glass from the door through the window opening.