Installation

INSTALLATION

Driver Seat




1. Before proceeding with the following repair procedure, review all warnings and cautions.

WARNING: Discard and replace the seat back bolts (1) with new bolts when servicing. Installing used bolts may result in the loosening of the seat back bolts after repair. Failure to follow these instructions may result in serious or fatal injury.

2. Install the seat back assembly (2) and install the new bolts (1).

3. Tighten the bolts to 40 Nm (30 ft. lbs.).




4. Position the side shields onto the seat adjuster tabs (1) and seat the clip (2) fully.




5. Install the outer side shield screw (2).




6. Install the clip (2) onto the recliner handle, if necessary.




7. Position the recliner handle (1) onto the spined shaft (2) and seat fully.




8. Install the height adjuster handle (1) and install the screws (2), if equipped.




9. Position the lift lever trim cap (2) and seat fully.




10. Position the inner side shields (2) and seat fully.

11. Install the seat cushion.

Passenger Seat





WARNING: Discard and replace the seat back bolts (2) with new bolts when servicing. Installing used bolts may result in the loosening of the seat back bolts after repair. Failure to follow these instructions may result in serious or fatal injury.

1. Install the seat back assembly (1) and install the new bolts (2).

2. Tighten the bolts to 40 Nm (30 ft. lbs.).




3. Position the side shields onto the seat adjuster tabs (1) and seat the clip (2) fully.




4. Install the screws (3) attaching the inboard and outboard side shields to the seat frame.

5. Install the recliner shields (1) and install the screws (5).

6. Connect the recliner cable ends (4) and fasten the cable housing (2) to the seat back frame.




7. Install both of the inner side shields (1).




8. Position the seat back (1) into the upright position.

9. Install the seat cushion.