Operation CHARM: Car repair manuals for everyone.
Home >> Jeep >> 2007 >> Compass 2WD L4-2.4L VIN W >> Repair and Diagnosis >> Powertrain Management >> Emission Control Systems >> Catalytic Converter >> Service and Repair >> Removal >> Removal - Maniverter
Manuals through 2025 now available!

Our trusted friends have launched a new website named LEMON, which has newer manuals. It also contains all the CHARM manuals.

LEMON is the spiritual successor to CHARM, I recommend you try it!

Link: lemon-manuals.la or lemon-manuals.org.ua

(Some people have issue connecting. LEMON is investigating. For now, use Firefox or change your DNS server)

Or, hide this message: temporarily or permanently

Removal - Maniverter






REMOVAL - MANIVERTER





WARNING: THE NORMAL OPERATING TEMPERATURE OF THE EXHAUST SYSTEM IS VERY HIGH. THEREFORE, NEVER ATTEMPT TO SERVICE ANY PART OF THE EXHAUST SYSTEM UNTIL IT IS COOLED. SPECIAL CARE SHOULD BE TAKEN WHEN WORKING NEAR THE CATALYTIC CONVERTER. THE TEMPERATURE OF THE CONVERTER RISES TO A HIGH LEVEL AFTER A SHORT PERIOD OF ENGINE OPERATION TIME.

NOTE: Before replacing a catalytic converter, determine the root cause of failure. Most catalytic converter failures are caused by air, fuel or ignition problems. Refer to the appropriate service diagnostic information for repair procedures.

1. Remove under floor catalytic converter.

NOTE: When replacement is required on any component of the exhaust system, original equipment parts (or equivalent) must be used.

2. Lower vehicle.
3. Remove secondary thermostat.
4. Remove maniverter mounting bolts.
5. Remove maniverter and gasket from the engine compartment.
pro multis · About Operation CHARM