Removal

LAMP

NOTE: The following procedure applies to either the front side marker lamps used on vehicles manufactured for the domestic market or to the repeater lamps used on vehicles manufactured for the export market. Although the lamps and bulbs are unique, the service procedures are the same.





1. Disconnect and isolate the battery negative cable.

2. Raise and support the vehicle.

3. Disconnect the ends of the jumper wire harness (3) from the front side marker/repeater lamp bulb socket and from the engine wire harness.

4. Remove and disassemble the front fender flare (6), reinforcement bracket (5) and wheel liner (2) from the vehicle. Take the proper precautions to protect the fender flare from cosmetic damage during disassembly.

5. Release the two integral latch features on the back of the lamp housing (4) and unhook the integral hook feature on the lamp housing from the slot in the lamp seat of the front fender flare reinforcement bracket.