Operation CHARM: Car repair manuals for everyone.
Home >> Jeep >> 2008 >> Grand Cherokee 2WD V6-3.0L DSL Turbo >> Repair and Diagnosis >> Powertrain Management >> Computers and Control Systems >> Fuel Level Sensor >> Service and Repair >> Fuel Pump Module - Removal
Manuals through 2025 now available!

Our trusted friends have launched a new website named LEMON, which has newer manuals. It also contains all the CHARM manuals.

LEMON is the spiritual successor to CHARM, I recommend you try it!

Link: lemon-manuals.la or lemon-manuals.org.ua

(Some people have issue connecting. LEMON is investigating. For now, use Firefox or change your DNS server)

Or, hide this message: temporarily or permanently

Fuel Pump Module - Removal







REMOVAL





1. Drain and remove fuel tank. Draining Fuel Tank
2. Note rotational position of pump module before attempting removal. An indexing arrow (4) is located on top of module for this purpose.
3. Disconnect pigtail harness connector (2) at pump module (7).
4. Disconnect fittings (3) and (6) from pump moduleService and Repair.




5. Position Lockring Remover/Installer 9340 (3) into notches on outside edge of lockring (5).
6. Install 1/2 inch drive breaker bar (1) to tool 9340 (3).
7. Rotate breaker bar counter-clockwise to remove lockring.
8. Remove lockring. The module will spring up slightly when lockring is removed.
9. Remove module from fuel tank. Be careful not to bend float arm while removing.
pro multis · About Operation CHARM