Operation CHARM: Car repair manuals for everyone.
Home >> Jeep >> 2008 >> Liberty 2WD V6-3.7L >> Repair and Diagnosis >> Heating and Air Conditioning >> Evaporator Temperature Sensor / Switch >> Service and Repair >> Removal
Manuals through 2025 now available!

Our trusted friends have launched a new website named LEMON, which has newer manuals. It also contains all the CHARM manuals.

LEMON is the spiritual successor to CHARM, I recommend you try it!

Link: lemon-manuals.la or lemon-manuals.org.ua

(Some people have issue connecting. LEMON is investigating. For now, use Firefox or change your DNS server)

Or, hide this message: temporarily or permanently

Removal







REMOVAL

WARNING: Disable the airbag system before attempting any steering wheel, steering column, or instrument panel component diagnosis or service. Disconnect and isolate the negative battery (ground) cable, then wait two minutes for the airbag system capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable the airbag system. Failure to take the proper precautions could result in accidental airbag deployment and possible personal injury or death.

NOTE: Illustration shown with instrument panel removed for clarity.





NOTE: LHD model shown. RHD model similar.

1. Disconnect and isolate the negative battery cable.
2. Partially remove the instrument panel to gain access to the evaporator temperature sensor (1) located in the rear of the HVAC housing (2), near the bottom of the instrument panel on the passenger side Instrument Panel - Removal.
3. Disconnect the instrument panel wire harness connector from the evaporator temperature sensor and remove the sensor from the HVAC housing.
pro multis · About Operation CHARM