Operation CHARM: Car repair manuals for everyone.
Home >> Jeep >> 2008 >> Liberty 2WD V6-3.7L >> Repair and Diagnosis >> Starting and Charging >> Charging System >> Alternator >> Service and Repair >> Generator - Removal
Manuals through 2025 now available!

Our trusted friends have launched a new website named LEMON, which has newer manuals. It also contains all the CHARM manuals.

LEMON is the spiritual successor to CHARM, I recommend you try it!

Link: lemon-manuals.la or lemon-manuals.org.ua

(Some people have issue connecting. LEMON is investigating. For now, use Firefox or change your DNS server)

Or, hide this message: temporarily or permanently

Generator - Removal







REMOVAL- 3.7L





CAUTION: Disconnect negative cable from battery before removing battery output wire from generator. Failure to do so can result in injury.

1. Disconnect and isolate negative battery cable at battery.

CAUTION: Never force a belt over a pulley rim using a screwdriver. The synthetic fiber of the belt can be damaged.

CAUTION: When installing a serpentine accessory drive belt, the belt MUST be routed correctly. The water pump will be rotating in the wrong direction if the belt is installed incorrectly, causing the engine to overheat. Refer to belt routing label in engine compartment, or refer to Belt Schematics in Cooling System.

2. Remove generator drive belt.
3. Unsnap plastic protective cover from B+ mounting stud.
4. Remove B+ terminal mounting nut at top of generator.
5. Disconnect field wire electrical connector at rear of generator by pushing on connector tab.
6. Remove one vertical generator mounting bolt (2) and two horizontal mounting bolts (3) and (4).
7. Remove generator (1) from vehicle.
pro multis · About Operation CHARM