Operation CHARM: Car repair manuals for everyone.
Home >> Jeep >> 2009 >> Commander 2WD V6-3.7L >> Repair and Diagnosis >> Body and Frame >> Doors, Hood and Trunk >> Trunk / Liftgate >> Trunk / Liftgate Motor >> Service and Repair >> Power Liftgate Drive Unit - Installation
Manuals through 2025 now available!

Our trusted friends have launched a new website named LEMON, which has newer manuals. It also contains all the CHARM manuals.

LEMON is the spiritual successor to CHARM, I recommend you try it!

Link: lemon-manuals.la or lemon-manuals.org.ua

(Some people have issue connecting. LEMON is investigating. For now, use Firefox or change your DNS server)

Or, hide this message: temporarily or permanently

Power Liftgate Drive Unit - Installation






INSTALLATION





1. Position the power liftgate drive unit assembly (1) into the vehicle.
2. Position the drive unit assembly lower mounting bracket onto the cargo floor stud (3).
3. Hook the drive unit assembly upper mounting bracket onto the D-pillar (2).
4. Install the drive unit retaining nut (4). Tighten the nut to 28.5 Nm (21 ft. lbs.).
5. Install the drive unit retaining bolts (5). Tighten the bolts to 28.5 Nm (21 ft. lbs.).
6. Connect the wire harness connector to the drive unit assembly (1).
7. Install the left quarter trim panel, Quarter Trim Panel - Installation.
8. Install the left rear D-pillar trim panel, Installation.
9. Install the link rod assembly, Power Liftgate Link Rod - Installation for the appropriate procedure.
10. Connect the battery negative cable.
11. Using an appropriate scan tool, check and erase any power liftgate control module diagnostic trouble codes.
12. Perform the power liftgate learn cycle, Programming and Relearning.
13. Verify power liftgate system operation.

pro multis · About Operation CHARM