Liftgate Weatherstrip - Installation
INSTALLATION
NOTE: Seat the lift gate weatherstrip fully into all corners without stretching. If in extreme cold temperatures preheating the weatherstrip to 23.8° C (75° F) may be required to fully seat the weatherstrip.
1. Install the weatherstrip to the upper right and left hand corners of the lift gate opening.
2. Using hand pressure seat the seal into the upper corners then seat across the header.
3. Seat the seal down the D-pillar to the lower flange on both sides.
4. Seat the seal along the lower flange to the slice joint.
5. Trim the weatherstrip if necessary, and connect the ends together along the flange.