Operation CHARM: Car repair manuals for everyone.
Home >> Jeep >> 2009 >> Wrangler 4WD V6-3.8L >> Repair and Diagnosis >> Cruise Control >> Cruise Control Switch >> Service and Repair >> Speed Control Switch - Installation
Manuals through 2025 now available!

Our trusted friends have launched a new website named LEMON, which has newer manuals. It also contains all the CHARM manuals.

LEMON is the spiritual successor to CHARM, I recommend you try it!

Link: lemon-manuals.la or lemon-manuals.org.ua

(Some people have issue connecting. LEMON is investigating. For now, use Firefox or change your DNS server)

Or, hide this message: temporarily or permanently

Speed Control Switch - Installation






INSTALLATION





Mounting hole (1) uses a screw. Depending on model line, mounting holes (2) may use either two screws, or one screw and a locating pin.





1. Connect electrical connector to speed control switch.
2. Install speed control switch mounting screws.
3. Tighten screws (1) to 1.6 Nm (15 in. lbs.). Make sure rubber seal is in place around switch.





4. Install horn switch.
5. Install three mounting fasteners.
6. Connect electrical connector to clockspring.
7. Install driver airbag. Driver Air Bag - Installation

WARNING: Do not connect battery negative cable yet. Refer first to airbag system test. Testing and Inspection

8. Reconnect battery using Airbag System Test procedure in Restraints. Testing and Inspection
9. Close hood.
10. Verify vehicle and system operation.

pro multis · About Operation CHARM