A/C Receiver Drier - Removal

REMOVAL

WARNING: Refer to the applicable warnings and cautions for this system before performing the following operation Warning and Caution . Failure to follow these instructions may result in possible serious or fatal injury.

CAUTION: The A/C receiver/drier must be replaced if an internal failure of the A/C compressor has occurred A/C Receiver Drier - Removal . Failure to replace the A/C Receiver Drier can cause serious damage to the replacement A/C compressor.






NOTE: Illustration shown with A/C condenser removed from vehicle for clarity.

1. Disconnect and isolate the negative battery cable.
2. Recover the refrigerant from the refrigerant system Refrigerant System Recovery.
3. Remove the grille Grille - Removal.
4. Remove the bolt (3) that secures the A/C receiver/drier (1) to the right side A/C condenser (2).
5. Disconnect the A/C receiver/drier from the A/C condenser and remove and discard the O-ring seals.
6. Install plugs in, or tape over the opened receiver/drier fittings and the condenser ports.