Toe Position

TOE POSITION

Before each alignment reading the vehicle should be jounced (rear first, then front). Grasp each bumper at the center and jounce the vehicle up and down three times. Always release the bumper in the down position.






NOTE: The wheel toe position adjustment is the final adjustment. This adjustment must be performed with the engine running, if the vehicle is equipped with power steering.

1. Start the engine and turn wheels both ways before straightening the steering wheel. Center and secure the steering wheel.
2. Loosen the adjustment sleeve clamp bolts (2).
3. Adjust the total toe with the tie rod. Turn the knurled adjuster until the correct total toe is reached. Center both sockets at the knuckles and tighten the clamp bolts to 61 Nm (45 ft.lbs). Make sure the toe setting does not change during clamp tightening.





4. Adjust the drag link adjuster sleeve so that the left and right toe values are equal. Verify the steering wheel is still straight. Position the clamps as shown and tighten to 35 Nm (26 ft. lbs.).
5. Verify the toe specifications and turn off the engine.