Shift Cable - Installation

INSTALLATION






NOTE: Transfer Case may not engage or disengage Four Wheel Drive Mode if the transfer case shift cable end bushings are damaged.

1. If necessary install new end bushings on the shift cable ends.
2. Route the shift cable through the opening in the floor pan.
3. Connect the transfer case shift cable to the shift lever body and pin.
4. Install any floor console components previously removed. Center Console - Installation
5. Verify that the floor shifter is in the N position.





6. Raise vehicle.
7. Route the shift cable through the opening in the shift cable support bracket.
8. Install the cable and a new spring clip into the slot in the support bracket.
9. Install any additional routing clips on the shift cable.
10. Verify that the transfer case is in the N position.
11. Attach the shift cable to the transfer case manual lever.
12. Lower vehicle and check for proper transfer case shifter operation.