Operation CHARM: Car repair manuals for everyone.
Home >> Jeep >> 2010 >> Commander 2WD V6-3.7L >> Repair and Diagnosis >> Brakes and Traction Control >> Disc Brake System >> Brake Caliper >> Service and Repair >> Removal and Replacement >> Disc Brake Caliper - Installation >> Front
Manuals through 2025 now available!

Our trusted friends have launched a new website named LEMON, which has newer manuals. It also contains all the CHARM manuals.

LEMON is the spiritual successor to CHARM, I recommend you try it!

Link: lemon-manuals.la or lemon-manuals.org.ua

(Some people have issue connecting. LEMON is investigating. For now, use Firefox or change your DNS server)

Or, hide this message: temporarily or permanently

Front






FRONT










1. Install the caliper (5) on the adapter (2).





2. Caliper slide pins should be free from debris and lightly lubricated.
3. Install the caliper slide pin bolts (2) and tighten to 44 Nm (32 ft. lbs.).
4. Gently lift one end of the slide pin boot to equalize air pressure, then release the boot and verify that the boot is fully covering the slide pin.

CAUTION: Verify brake hose is not twisted or kinked before tightening banjo bolt.

5. Install brake hose (5) to caliper (1) with new copper washers (6) and tighten banjo bolt (6) to 31 Nm (23 ft. lbs.).

6. Remove the prop rod from the brake pedal.
7. Bleed the area of repair for the brake system, If a proper pedal is not felt during bleeding an area of repair then a base bleed system must be performed.Service and Repair.
8. Install wheel and tire assemblies.
9. Remove supports and lower vehicle.
10. Verify brake fluid level.
pro multis · About Operation CHARM