Operation CHARM: Car repair manuals for everyone.
Home >> Jeep >> 2010 >> Commander 2WD V6-3.7L >> Repair and Diagnosis >> Heating and Air Conditioning >> Evaporator Temperature Sensor / Switch >> Service and Repair >> Front Evaporator Temperature Sensor - Removal
Manuals through 2025 now available!

Our trusted friends have launched a new website named LEMON, which has newer manuals. It also contains all the CHARM manuals.

LEMON is the spiritual successor to CHARM, I recommend you try it!

Link: lemon-manuals.la or lemon-manuals.org.ua

(Some people have issue connecting. LEMON is investigating. For now, use Firefox or change your DNS server)

Or, hide this message: temporarily or permanently

Front Evaporator Temperature Sensor - Removal






REMOVAL

WARNING: Disable the airbag system before attempting any steering wheel, steering column or instrument panel component diagnosis or service. Disconnect and isolate the negative battery (ground) cable, then wait two minutes for the airbag system capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable the airbag system. Failure to follow these instructions may result in accidental airbag deployment and possible serious or fatal injury.






NOTE: LHD model shown. RHD model similar.

1. Disconnect and isolate the negative battery cable.
2. On LHD models, remove the instrument panel silencer from the driver side of the instrument panel.
3. On RHD models, remove the glove box from the instrument panel Instrument Panel Glove Box - Removal.
4. Disconnect the HVAC wire harness connector (1) from the evaporator temperature sensor (2) located on the left side of the HVAC housing (3).
5. Remove the evaporator temperature sensor from the HVAC housing.

pro multis · About Operation CHARM