Operation CHARM: Car repair manuals for everyone.
Home >> Jeep >> 2010 >> Commander 2WD V8-5.7L >> Repair and Diagnosis >> Engine, Cooling and Exhaust >> Engine >> Service and Repair >> Removal and Replacement >> Structural Dust Cover - Installation
Manuals through 2025 now available!

Our trusted friends have launched a new website named LEMON, which has newer manuals. It also contains all the CHARM manuals.

LEMON is the spiritual successor to CHARM, I recommend you try it!

Link: lemon-manuals.la or lemon-manuals.org.ua

(Some people have issue connecting. LEMON is investigating. For now, use Firefox or change your DNS server)

Or, hide this message: temporarily or permanently

Structural Dust Cover - Installation






INSTALLATION

CAUTION: The structural dust cover must be installed as described in the following steps. Failure to do so may cause severe damage to the cover.






1. Position the structural dust cover in the vehicle
2. Install all four bolts retaining the structural dust cover to the engine (3) hand tight.
3. Install the four cover to transmission bolts (1, 2 & 4) hand tight.

CAUTION: The structural dust cover must be held tightly against both the engine and the transmission bell housing during the tightening sequence. Failure to do so may cause severe damage to the cover.

4. Tighten the structural dust cover-to-transmission bolts (1, 2 & 4) to 9 Nm (80 in. lbs.).
5. Tighten the structural dust cover-to-engine block bolts (3) to 9 Nm (80 in. lbs.).
6. Retighten the structural dust cover-to-transmission bolts to 54 Nm (40 ft. lbs.).
7. Retighten the structural dust cover-to-engine block bolts to 54 Nm (40 ft. lbs.).





8. Lower the transmission onto the crossmember and remove the jack.
9. Install the transmission mount to crossmember retaining nuts (1) and tighten to 54 Nm (40 ft. lbs.).





10. Position the steering rack to the frame, install the bolts (1) and tighten bolts/nuts to 258 Nm (190 ft. lbs.).
11. Lower the vehicle.
pro multis · About Operation CHARM