Operation CHARM: Car repair manuals for everyone.
Home >> Jeep >> 2010 >> Commander 2WD V8-5.7L >> Repair and Diagnosis >> Lighting and Horns >> Service and Repair >> Front Lamp Unit - Removal >> Lamp
Manuals through 2025 now available!

Our trusted friends have launched a new website named LEMON, which has newer manuals. It also contains all the CHARM manuals.

LEMON is the spiritual successor to CHARM, I recommend you try it!

Link: lemon-manuals.la or lemon-manuals.org.ua

(Some people have issue connecting. LEMON is investigating. For now, use Firefox or change your DNS server)

Or, hide this message: temporarily or permanently

Lamp






LAMP





1. Disconnect and isolate the battery negative cable.
2. Remove the cover from over the top of the front lamp unit. Front Lamp Unit - Removal.
3. Remove the grille from the front of the vehicle. Grille - Removal.
4. Remove the fascia from the front of the vehicle. Front Bumper Fascia - Removal.
5. If the front lamp being serviced is on the same side of the vehicle as the engine fresh air intake tube, unsnap the air intake tube from the air cleaner housing and remove it from between the lamp and the radiator yoke hydroform.
6. Remove the three screws (2) that secure the two lower and the upper inboard lamp (4) mounting brackets to the front end sheet metal.
7. Remove the push pin fastener (3) that secures the upper outboard lamp mounting bracket to the top of the radiator yoke hydroform (5).





8. Pull the lamp (2) away from the radiator yoke hydroform (1) at the front of the vehicle far enough to access and disconnect the headlamp and dash wire harness connector (3) from the pigtail connector (4) on the back of the lamp housing.
9. Remove the lamp unit from the vehicle.

pro multis · About Operation CHARM