Multiple Displacement Solenoid - Removal

REMOVAL





1. Disconnect and isolate the negative battery cable.
2. Remove the intake manifold Intake Manifold - Removal.
3. Remove foam insulator pad (1).





4. Remove the Multiple Displacement Solenoid (MDS) (2) electrical connector(s) (1).
5. Remove the MDS solenoid (2) retaining bolt(s) (3).






CAUTION: Do not try to pry the solenoid out. This could lead to breakage and contamination of the lubrication system.

6. Lightly tap on the MDS solenoid(s) with a rubber mallet. Rotate the MDS solenoid(s) from side to side to break the seal.
7. Remove the MDS solenoid(s).