Service Procedure

A. Inspect Brake Pedal Linkage Clip (Dodge Ram Trucks Only)

NOTE:
This procedure only applies to Dodge Ram truck models. All other vehicles proceed to Section B of this repair procedure.

1. Open the driver's front door.





2. Looking up under the instrument panel, by the brake pedal arm, inspect for the presence of a brake pedal linkage clip at the brake booster input rod (Figure 1):

> If the brake pedal linkage clip is present, no further action is required.

> If the brake pedal linkage clip is missing, install a new clip.

NOTE:
An audible "click" will be heard when the clip is properly installed.

B. Replace Brake Pedal Linkage Clip (All Models except Dodge Ram Trucks)

1. Open the driver's front door.

2. Vehicles equipped with a hush panel, remove the hush panel to gain access to the brake pedal linkage clip.

3. Remove and discard the original brake pedal linkage clip (Figure 2).





4. Install a new brake pedal linkage clip (Figure 2).

NOTE:
An audible "click" will be heard when the clip is properly installed.

5. Vehicles equipped with a hush panel, install the hush panel.