Valve Springs - Installation

INSTALLATION





1. Install the valve seal.
2. Install the valve spring.
3. Using the Valve Spring Compressor 9065A (1), compress the valve spring and install the valve spring retainer and locks.





4. Release the air charge in the cylinder (1).
5. Remove the spring compressor tool 9065A (3).

CAUTION: Verify that the pushrods are fully seated into lifter and the rocker arm. Recheck after the rocker arm shaft has been tightened to specification.





6. Install the rocker arm shaft and pushrodsValve Rocker Arm - Installation.
7. Tighten the rocker shaft bolts to 22 Nm (16 ft. lbs.) using sequence shown.





8. Remove the Pushrod Retainer 9070 (1).





9. Install cylinder head cover (1).





10. Tighten cylinder head cover bolts and double ended studsCylinder Head Cover(s) - Installation.
11. Install spark plugs.





12. Install ignition coil on plug (2), and tighten fasteners (3) to 7 Nm (62 in. lbs).
13. Install ignition coil connectors (1).
14. Install air cleaner assembly Air Cleaner Body - Installation.
15. Connect negative battery cable.