Intake Manifold - Installation

INSTALLATION





1. Install the intake manifold seals.
2. Carefully position the intake manifold without disturbing the seals.
3. Apply Mopar(R) Lock & Seal Adhesive to the intake manifold retaining bolts.
4. Using the sequence shown, install the intake manifold retaining bolts and tighten to 12 Nm (9 ft. lbs).

NOTE: The factory fuel injection wiring harness is numerically tagged (INJ 1, INJ 2, etc.) for injector position identification. If the harness was not tagged, note the wiring location previously marked before removal.

5. Connect the fuel injector electrical connectors.





6. Connect the fuel supply line quick connect fitting (1) at the fuel rail and install the safety retainer clip.





7. Connect the brake booster vacuum hose, vapor purge vacuum hose (2), and the make up air (MUA) hose (1).





8. Connect the manifold air pressure (MAP) sensor connector (1) located at the back of the intake manifold.
9. Connect the throttle body electrical connector.





10. Install the clean air tube (1).
11. Connect the intake air temperature (IAT) sensor connector (2).





12. Install the engine covers (1), they snap on the fuel rail ball studs (2).
13. Connect the negative battery cable.