Tail Stop Turn Lamp Bulb - Removal

BULB - DOMESTIC






NOTE: The rear lamp unit for domestic markets (1) contains two bulbs: park/rear side marker/stop/turn signal (2) and backup (3). The service procedures for each bulb are the same, only the bulb sizes and types may differ.

1. Disconnect and isolate the battery negative cable.
2. Remove the rear lamp unit (1) from the end of the quarter panel. Tail Stop Turn Lamp - Removal.
3. Firmly grasp the bulb socket on the back of the rear lamp unit housing and rotate it counterclockwise about 30 degrees to unlock it.
4. Pull the socket and bulb straight out from the keyed opening in the housing.
5. Pull the base of the bulb straight out of the socket.