Operation CHARM: Car repair manuals for everyone.
Home >> Jeep >> 2010 >> Grand Cherokee SRT-8 V8-6.1L >> Repair and Diagnosis >> Starting and Charging >> Charging System >> Alternator >> Service and Repair >> Generator - Installation
Manuals through 2025 now available!

Our trusted friends have launched a new website named LEMON, which has newer manuals. It also contains all the CHARM manuals.

LEMON is the spiritual successor to CHARM, I recommend you try it!

Link: lemon-manuals.la
If it fails: lemon-manuals.org.ua

Or, hide this message: temporarily or permanently

Generator - Installation






6.1L





1. Position the generator (2) to the engine and install the two mounting bolts (1).Torque the bolts to 41 Nm (30 ft. lbs.).
2. Snap the field wire connector (3) into the rear of the generator.
3. Install the B+ terminal eyelet to the generator output stud.Tighten the mounting nut to 12 Nm (108 in. lbs.).






CAUTION: Never force a belt over a pulley rim using a screwdriver. The synthetic fiber of the belt can be damaged.

CAUTION: When installing a serpentine accessory drive belt, the belt must be routed correctly. The water pump may be rotating in the wrong direction if the belt is installed incorrectly, causing the engine to overheat. Refer to belt routing label in engine compartment, or Refer to the Belt Schematics in Cooling System.

4. Install the serpentine belt Serpentine Accessory Drive Belt - Installation.
5. Install the air cleaner Installation.
6. Install the negative battery cable.

pro multis · About Operation CHARM