Rear

LAMP






NOTE: The following procedure applies only to vehicles manufactured for export markets. Rear fog lamps are not available in vehicles manufactured for domestic markets.

1. Disconnect and isolate the battery negative cable.
2. Raise and support the vehicle.
3. From behind the outboard end of the rear bumper (1) disconnect the take out and connector (4) of the rear bumper wire harness from the rear fog lamp bulb socket.
4. Remove the two nuts (2) that secure the two mounting studs on the lamp housing to the retainer cap (3) on the back of the rear bumper cover.
5. Remove the lamp from the face of the rear bumper cover.