Operation CHARM: Car repair manuals for everyone.
Home >> Jeep >> 2011 >> Compass 2WD L4-2.0L >> Repair and Diagnosis >> Lighting and Horns >> Service and Repair >> Front Lamp Unit - Installation
Manuals through 2025 now available!

Our trusted friends have launched a new website named LEMON, which has newer manuals. It also contains all the CHARM manuals.

LEMON is the spiritual successor to CHARM, I recommend you try it!

Link: lemon-manuals.la or lemon-manuals.org.ua

(Some people have issue connecting. LEMON is investigating. For now, use Firefox or change your DNS server)

Or, hide this message: temporarily or permanently

Front Lamp Unit - Installation





LAMP - MK49





1. Position the front lamp unit (5) close enough to the front of the vehicle to reconnect the Front End Module (FEM) wire harness connections to the back of the lamp housing.
2. Position the lamp to the FEM support structure on the front of the vehicle.
3. Install and tighten the screw (2) that secures the gap adjuster (3) on the lower outboard front lamp unit mounting bracket to the outboard end of the lower FEM hydroform support structure. Tighten the screw to 2.8 Nm (25 in. lbs.).
4. Install and tighten the nut (4) that secures the lower inboard front lamp unit mounting bracket to the stud on the inboard end of the lower FEM hydroform support structure. Tighten the nut to 2.8 Nm (25 in. lbs.).
5. Install and tighten the screw (1) that secures the upper front lamp unit mounting bracket to the upper FEM hydroform support structure. Tighten the screw to 2.8 Nm (25 in. lbs.).
6. If necessary, loosen the nut on the gap adjuster to adjust the clearance between the front lamp unit and the front fender lamp opening. Acceptable clearance is from 0 to 4 millimeters (0 to 0.15 inches).
7. Reinstall the fascia onto the front of the vehicle. Front Bumper Fascia - Installation.
8. Reconnect the battery negative cable.
9. Confirm proper headlamp alignment. Adjustments.

pro multis · About Operation CHARM