Operation CHARM: Car repair manuals for everyone.
Home >> Jeep >> 2011 >> Wrangler V6-3.8L >> Repair and Diagnosis >> Body and Frame >> Relays and Modules - Body and Frame >> Seat Temperature Control Module >> Service and Repair >> Heated Seat Module - Removal
Manuals through 2025 now available!

Our trusted friends have launched a new website named LEMON, which has newer manuals. It also contains all the CHARM manuals.

LEMON is the spiritual successor to CHARM, I recommend you try it!

Link: lemon-manuals.la or lemon-manuals.org.ua

(Some people have issue connecting. LEMON is investigating. For now, use Firefox or change your DNS server)

Or, hide this message: temporarily or permanently

Heated Seat Module - Removal






REMOVAL

WARNING: Disable the airbag system before attempting any steering wheel, steering column, or instrument panel component diagnosis or service. Disconnect and isolate the negative battery (ground) cable. Wait two minutes for the airbag system capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable the airbag system. Failure to follow these instructions may result in possible serious or fatal injury.

CAUTION: Use care when removing the Heated Seat Module (HSM) from the seat to prevent damage to the plastic HSM housing and retainer. Failure to follow these instructions may result in damage to the HSM and retainer.





1. Disconnect and isolate the negative battery cable.
2. Remove the radio Radio - Removal.
3. Using an appropriate door trim tool or needle nose pliers, disengage the tab and push-pin retainer that secures the Heated Seat Module (HSM) (1) to the instrument panel support (2).
4. Disconnect the wire harness connector (3) from the HSM.
5. Remove the HSM from the instrument panel.
.
pro multis · About Operation CHARM