Front Bumper - Installation

INSTALLATION

1. Install the cross bracing on the bumper beam (2) and transfer any miscellaneous parts as needed.
2. Position the bumper and install the four bolts (4) securing the beam to the vehicle frame.
3. Install the outer two bolts (3) that secure the beam to the radiator closure panel.
4. Tighten the four inner Bolts (4) to 26 Nm (19 ft. lbs.) and the two outer bolts (3) to 9 Nm (7 ft. lbs.).

5. Position the isolator pad (1) and install the push-pin type retainers (2).
6. Position the headlamp electrical harness and secure in place.
7. Position back and secure the power steering cooler assembly, if equipped.

8. Install both the side plastic air deflectors (1).
9. Install the hood latch assembly and upper radiator support cross bracing, Hood Latch - Installation.
10. Install the radiator grille assembly, Grille - Installation.
11. Connect the negative battery cable.