Operation CHARM: Car repair manuals for everyone.
Home >> Kia >> 1996 >> Sephia Sedan L4-1.6L >> Repair and Diagnosis >> Powertrain Management >> Computers and Control Systems >> Crankshaft Position Sensor >> Testing and Inspection
Manuals through 2025 now available!

Our trusted friends have launched a new website named LEMON, which has newer manuals. It also contains all the CHARM manuals.

LEMON is the spiritual successor to CHARM, I recommend you try it!

Link: lemon-manuals.la or lemon-manuals.org.ua

(Some people have issue connecting. LEMON is investigating. For now, use Firefox or change your DNS server)

Or, hide this message: temporarily or permanently

Crankshaft Position Sensor: Testing and Inspection


Sensor Inspection





1. Disconnect the three-pin crankshaft position sensor connector.
2. Measure the resistance between terminals 1 and 2 wit an ohmmeter.

Resistance: 500 - 600 ohms at 68°F [20°C]

3. If not as specified, replace the crankshaft position sensor.
4. Measure the resistance between terminal 3 of connector C164 (wiring harness side) and engine ground.

Resistance: Approximately 0 ohms

5. If not as specified, check for an open in the circuit.
6. Connect the crankshaft position sensor connector.

Air Gap Inspection





1. Measure the air gap between the crankshaft pulley and the crankshaft position sensor by using a feeler gauge.

Specification: 0.020- 0.059 in (0.5- 1.5 mm)

2. If not as specified, replace the crankshaft pulley or the crankshaft position sensor.

pro multis · About Operation CHARM