Upper Arm

REMOVAL
1. Remove the wheel and tire.
2. Loosen the ball joint nut but do not remove it.





3. Using the special tool, disconnect the upper arm ball joint from the knuckle.





4. Remove the 2 nuts from the wheel house panel then remove the upper arm assembly.





5. Remove the upper arm shaft.
6. Installation is reverse of removal.

INSPECTION
1. Check the bushing for wear and deterioration.
2. Check the upper arm for bending or breakage.





3. Check the ball joint for rotating torque.
1) If there is a crack in the dust cover, replace it and add grease.
2) Shake the stabilizer link ball joint stud several times.
3) Mount the self-locking nut on the ball joint, and then measure the ball joint rotating torque.
Standard value 0.5 - 1.5 Nm (5 - 15 kg cm, 4.43 - 13.27 in. lbs)
4) If the rotating torque exceeds the upper limit of standard value, replace the upper arm assembly.
5) Even if the rotating toque is below the lower limit of the standard value, the ball joint may be reused unless it has drag and excessive play.