Shift Interlock: Testing and Inspection

SHIFT LOCK SYSTEM

OPERATION INSPECTION
1. Turn ignition switch to "ON" position.
2. Verify that the selector lever is shifted to P range.
3. Verify that the selector lever isn't shifted from P range to any other position with not applying the brake pedal.





4. Verify that selector lever isn't shifted without applying the brake pedal.
5. Shift the selector lever to R range.
6. Verify that ignition switch isn't shifted to LOCK position.
7. Shift the selector lever to P range.
8. Verify that ignition switch isn't shifted to LOCK position.
9. Repair it if necessary.

MANUAL RELEASE METHOD OF SHIFT LOCK
1. Verify that the selector lever locks on the P range.
2. Press screwdriver after opening cap and putting it into the hole.





3. Shift selector lever.

ACTUATOR VOLTAGE & CONTINUITY INSPECTION
1. Remove console.

NOTE: Remove F-07 connector when checking the continuity between connector terminal and ground terminal.

2. Shift the selector lever to P range and inspect terminal voltage and continuity.








3. Replace the actuator or repair wiring harness if necessary.