Oil Pump: Service and Repair

OIL PUMP

Part 1:

Part 2:

COMPONENT

REMOVAL
1. Disconnect negative battery cable.
2. Drain engine oil.
3. Remove Drive belt.
4. Remove timing belt.
5. Remove components in the order shown in figure.

INSPECTION
1. Clean all components and clean off dust from all components.





2. Check all components with specifications and replace as necessary.

INSTALLATION





1. Apply continuous sealant to mating surface as shown illustration.
Sealant type: LOCTITE 5900
Bead width: 0.0394 - 0.0787 inch (1 - 2 mm)

NOTE:
^ Clean the foreign material from mating surface before applying sealant.
^ Be careful for sealant not to enter the oil hole.

2. Install the oil pump.
Tightening torque: 13.7 - 18.8 ft. lbs. (18.6 - 25.5 Nm, 1.9 - 2.6 kgf-cm)