Control Valve Body (Replacement)

CONTROL VALVE BODY (REPLACEMENT)





1. Install control valve body, (8) bolts, and wiring clips as shown.
Bolt length (measured from below the head)
A: 1.18 inch (30 mm)
B: 1.97 inch (50 mm)
Tightening torque: 69.6 - 94.8 inch lbs. (7.9 - 10.7 Nm, 80 - 110 kg-cm)
2. Install oil strainer, and (3) bolts.
Tightening torque: 69.6 - 94.8 inch lbs. (7.9 - 10.7 Nm, 80 - 110 kg-cm)
3. Connect connectors.
4. Install oil pan (19 bolts) and a new gasket.
Tightening torque: 74.4 - 94.8 inch lbs. (8.4 - 10.7 Nm, 85 - 110 kg-cm)
5. Loosely install nuts A and bolts B of engine mounting member.





6. Install engine mounting member.
Tightening torque:
A: 28 - 38 ft. lbs. (38 - 51 Nm, 38 - 53 kg-m)
B: 48 - 65 ft. lbs. (64 - 89 Nm, 6.5 - 9.1 kg-m)
7. Install both gravel shield to under engine.
8. Remove SST (OK201 170 AA0) from engine.
9. Pour in ATF. Check ATF level with engine idling and check for leaks, refer to Automatic Transmission Fluid.
10. Drive vehicle and check shift points, shift schedule, and shift quality.