Disassembly

DISASSEMBLY






1. Remove the reservoir cap and drain the brake fluid into a suitable container.
2. Remove the fluid level sensor.





3. Remove the reservoir from the master cylinder after mounting screw (A).





4. Remove the proportioning valves (A) - Conventional brake system.





5. Remove the retainer ring by using the snap ring pliers.
6. Remove the pin with the primary piston pushed completely using a screwdriver. Remove the primary piston assembly.





7. Remove the pin with the secondary piston pushed completely using a screwdriver. Remove the secondary piston assembly.

NOTE: Do not disassemble the primary and secondary piston assembly.