Front

INSPECTION OF FRONT DISC BRAKE PAD
1. Check the brake pad thickness through the caliper body inspection hole.

Pad thickness Standard value : 11.0 mm (0.43 in.) / Service limit : 2.0 mm (0.0787 in.)





CAUTION:
a. If the pad lining thickness is out of specification, left and right pads must be replaced as a complete set.
b. When the thickness difference between the left pad and right pad is large, check the sliding condition of the piston and the guide rod.

INSPECTION OF REAR DISC BRAKE PAD
1. Check the brake pad thickness through the caliper body inspection hole.

Pad thickness Standard value : 10.0 mm (0.39 in.) / Service limit : 2.0 mm (0.0787 in.)





CAUTION:
a. If the pad thickness is out of specification, left and right pads must be replaced as a complete set.
b. When the thickness difference between the left pad and right pad is large, check the sliding condition of the piston and the guide rod.