Repair Procedures

REMOVAL AND INSTALLATION

1. Remove floor console assembly.
2. Remove front pillar trim.
(1) Remove body side weatherstrip.




(2) Remove pillar blanking cover and bolt.




(3) Remove trim from front pillar.




3. Remove cowl side trim.
(1) Remove front door scuff trim.








(2) Remove cowl side trim.








4. Remove side cover.




5. Remove center crash pad side cover(LH/RH).




(1) Remove screws(6).
(2) Remove center crash pad side cover.
6. Remove lower panel(LH).
(1) Remove hood release handle cable.




(2) Remove screws(4).




(3) Disconnect lower panel connector.




(4) Remove lower panel from instrument panel.
7. Remove steering wheel and column cover.
Remove steering shaft from cowl cross bar.
Put steering wheel, column cover, and steering shaft on floor.
8. Remove glove box.
(1) Remove guide and damper wire.




(2) Remove hinge pins(2).




(3) Remove glove box.




9. Remove instrument panel assembly.
(1) Remove mounting bolts(12).




(2) Disconnect fuse box and electrical connector.
(3) Remove audio antenna cable.




(4) Remove instrument panel assembly.
10. Install in reverse order of removal.