Operation CHARM: Car repair manuals for everyone.
Home >> Kia >> 2009 >> Rondo L4-2.4L >> Repair and Diagnosis >> A L L Diagnostic Trouble Codes ( DTC ) >> Testing and Inspection >> C Code Charts >> C1237 >> Component Inspection
Manuals through 2025 now available!

Our trusted friends have launched a new website named LEMON, which has newer manuals. It also contains all the CHARM manuals.

LEMON is the spiritual successor to CHARM, I recommend you try it!

Link: lemon-manuals.la or lemon-manuals.org.ua

(Some people have issue connecting. LEMON is investigating. For now, use Firefox or change your DNS server)

Or, hide this message: temporarily or permanently

Component Inspection





Component Inspection

1. Ignition "ON" & Engine "OFF".
2. Put and release the brake pedal several times.
3. Measure voltage between terminal "1" of the pressure sensor harness connector and chassis ground.
A. Specification : 0.2 ± 0.1V ~ 4.8 ± 0.1V




4. Is the measured voltage, waveform within specifications?
YES
1) Fault is intermittent caused by poor connection in pressure sensor harness and/or HECU's connector or was repaired and HECU memory was not cleared. Go to "Verification of vehicle Repair" procedure.
NO
1) Substitute with a known-good pressure sensor and check for proper operation. If problem is corrected, replace pressure sensor and then go to "Verification of Vehicle Repair" procedure.
pro multis · About Operation CHARM