Front Door Window Regulator: Service and Repair

Door Module Assembly Replacement
1. Remove the following parts:
A. Front door trim
B. Window glass
C. Outside handle
2. Loosen the mounting bolt (A).




3. After loosening the door module mounting bolts, then remove the front door module (A).

Tightening torque:
6.9 - 10.8 N.m (0.7 - 1.1 kgf.m, 5.1 - 8.0 lb-ft)




4. Disconnect the outside handle connector (A) and outside handle rod (B).




5. Disconnect the connectors and door module wiring harness (A).




6. Installation is the reverse of removal.

NOTE:
- The area of whole parts should be applied with sufficient grease.
- Make sure connectors are connected properly and each rod is connected securely.
- Make sure the door locks/unlocks and opens/closes properly.