Repair Procedures

Inspection

Check it by the procedure below to see if the function of the ECM is normal.
1. Turn the ignition key to the "ON" position.
2. Cover the forward looking sensor to stop functioning.
3. Head a light to the rearward looking sensor.
4. The ECM should be darkened as soon as the rearward looking sensor detects the light.

NOTE:
If this test is performed in daytime, the ECM may be darkened as soon as the forward looking sensor is covered.

5. When the reverse gear is engaged, the ECM should not be darkened.
When heading lights to both the forward looking and rearward looking sensors, the ECM should not be darkened.

Removal

1. Remove the mirror wire cover(A) and connector(B).




2. Remove the ECM mirror screw(A).




3. Remove the inside rear view mirror(A) pulling it upside carefully.





NOTE:
Make sure the mounting bracket and mirror not to be damaged.

Installation

1. Install the inside rear view mirror.
2. Connect the inside rear view mirror connector.
3. Install the mirror wire cover.