Repair Procedures

Replacement

Floor Console Replacement
[M/T]

CAUTION:
- A plastic trim tool is recommended, but if prying with a screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
- Put on gloves to protect your hands.

1. Using a screwdriver or remover, remove the gear boots (A).




2. Using a screwdriver or remover, remove the console upper cover (A).




3. Using a screwdriver or remover, remove the parking brake cover (A).




4. Remove the floor console pad (A).




5. After loosening the mounting bolts and clips, then remove the floor console assembly (A).




6. Installation is the reverse of removal.

NOTE:
- Make sure the connector are connected in properly.
- Replace any damage clips.

[A/T]

CAUTION:
- A plastic trim tool is recommended, but if prying with a screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
- Put on gloves to protect your hands.

1. Using a screwdriver or remover, remove the gear boots (B) and gear knob (A).




2. Using a screwdriver or remover, remove the console upper cover (A).




3. Disconnect the connectors (A).




4. Using a screwdriver or remover, remove the parking brake cover (A).




5. Remove the floor console pad (A).




6. After loosening the mounting bolts, screws, clips, then remove the floor console assembly (A).




7. Installation is the reverse of removal.

NOTE:
- Make sure the connectors are connected in properly.
- Replace any damaged clips.