Bulb Replacement

BULB REPLACEMENT
The heater/ventilation control panel is illuminated by four 12-volt 1.2 watt wedge type (capless) bulbs. In the event of a bulb failure a replacement bulb can be fitted as follows:

Control Panel & Levers:

- Pull the five finger tip knobs off the control levers.
- Remove the two screws at the top of the panel.
- Carefully ease the panel away from the center console only as far as the electrical leads will permit.
- Pull the appropriate bulb holder out of the rear of the panel.
- Pull the bulb from the holder.
- Fit a new bulb and push the bulb holder firmly back into its location at the rear of the panel.

REFIT
- Be sure that the electrical leads do not become trapped between the panel console and operating levers and refit the panel.